youtor.org
#############################
Video Source: www.youtube.com/watch?v=qcnaolrWheM
Korky® Universal Toilet Repair Kit 4010PK • Fix your leaking, noisy, or running toilet in 1 trip • Universal replacement for faulty fill valves ballcocks • Kit includes: Toilet fill valve, flush valve, Korky Plus toilet flapper, tank-to-bowl gasket, nuts, bolts and washers • Fixes: No/slow filling toilet, toilet constantly running, noisy flushing toilet, leak between tank bowl • Stainless steel chain • Korky® Universal Toilet Repair Kit 4010PK | http://bit.ly/1tfGvRH • Hi I’m Jewels and welcome to in the tank with Korky. Today I will be your personal guide in showing you how to install the Korky QuietFILL complete repair kit. The first step is to shut off your water supply to your toilet by turning the valve clockwise. Flush your toilet to get rid of excess water in the toilet. Place a bucket or pale under the toilet tank to catch the excess water from the supply line and toilet tank. Next, sponge out the remaining water in the toilet tank. Disconnect the water supply line … and unscrew the mounting nut. Pull up on the old valve and lift out of the toilet tank. Locate and remove all old nuts, washers, and bolts from the toilet tank. Carefully lift up on the tank and remove from the bowl. Remove the old tank to bowl sponge gasket. With a large wrench remove the old mounting nut and pull the old flush valve and flapper out of the toilet tank. Discard all removed components. Place your new Korky flush valve into the toilet tank and slide the chipboard washer over the threads, hand tighten the mountin nut. Place the new red sponge gasket over the mounting nut threads. Carefully set the tank onto the bowl. Using the new bolts, rubber washers, washers and hex nuts included in the packaging, attach the tank to the bowl while applying downward pressure to keep the tank level. Tighten the bolts in an alternating fashion to ensure a proper seal on the red sponge gasket. Do not over tighten the bolts, doing so may cause the porcelain to crack. Next, set the height of the flush valve. Loosen the lock nut and extend the overflow tube until the top of the overflow tube is one inch below the flush lever nut and hand tighten the locknut. Pull out the valve, place into your toilet tank. To adjust the height, push down until the fill valve water line and tank water line match. Remove toilet fill valve, lock the fill valve in place by simply twisting the upper half clockwise. As a double check, make sure the grooves match up with the pegs. Place the Korky Quietfill toilet Fill Valve into your toilet tank and hand tighten the mounting nut. Insert the metal clip on one end of the refill tube and attach onto the overflow tube. Then install the opposite end to the fill valve. If kinking occurs, simply cut the refill tube with a scissors to shorten the overall length. Attach the flapper chain to the flush lever hole most directly above the flapper with minimal chain slack. Reconnect the water supply line. Then turn on the water supply line by turning the valve counter clockwise until fully open. • If you need further assistance with the installation, visit our website or contact us at 1-800-LAVELLE.
#############################
