4l60E to 4L80E Swap Pt 2 Driveshaft and Wiring

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=0wX1MwXTnnI

In the last upload, I physically mounted the 4l80e to the 5.3 LS using the flat 6.0 flexplate and crankshaft spacer, and then modified the crossmember to hold up the transmission since the rear mount is in a different place. This time, I'll go over the last steps to connect the 4l80e to the driveshaft and get the wiring sorted out. This requires swapping a yoke for the 4l80e onto the driveshaft that the 4l60 was attached to, and a wiring harness adapter for the 4l80 that will allow the electronic connections to be made and the input speed sensor to be connected to the computer, and lastly, you will need to segment swap the computer to allow the 4l80e to be properly controller. • Parts Used from Amazon • Conversion U joint • https://amzn.to/2S7mgcQ • 32 spline slip yoke • https://amzn.to/3ihFeIw • Speed Sensor input harness • https://amzn.to/3ij6gzf • Late model 4l80e internal wiring harness • https://amzn.to/30eUHCF

#############################

New on site