Using Bearings with 3D Printed Parts

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=8V8MH2k8Igs

When I first started working with 3D-printed parts, I found myself wanting to incorporate new mechanical components, but I had very little knowledge of how to do so. I've found that there is a gap in information available online for things that are fairly simple but not self-explanatory in this segment, so I've set out to teach all the things I wish I had known when I was just starting out. • 0:00 - 0:34 Intro and Principles • 0:35 - 2:24 Where to buy, getting started, lubrication • 2:25 - 5:00 Mounting bearings to 3D printed parts • 5:01 - 6:50 Mounting shafts • 6:51 - 7:16 Specialty bolts and other considerations • 7:17 - 7:54 My final recommendation, farewell • Link to a 100-pack of bearings for ~$20 on Amazon: • https://amzn.to/3VTCo0Q • A good 20-pack if 100 is too much: • https://amzn.to/3BYf9Lh • My 3D Printer since people always ask: • https://amzn.to/3Fsa9ze • My free designs on Thingiverse: • https://www.thingiverse.com/christoph... • Christopher's Factory Instagram: • / christophersfactory • Subscribe :)

#############################

New on site