Getting a Mclane Edger Working

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=TVCJxW4-dAE

This one was pretty simple, it was given to a family member who uses it every now and then. Last time they tried to it wouldn't start, classic case of a dirty carb and dirty gas. I replaced the bearings in a seperate video. • Replacing Bearings in Edger Spindle • Buy parts here • Diaphragm • https://amzn.to/3kqCHin • PCV Elbow • https://amzn.to/37ZWaDY • Carb rebuild kit • https://amzn.to/3kuOw7e • Points and Condenser (If equipped) • https://amzn.to/3F3SwW3 • Pick up tube (make sure it is correct length for your tank) • https://amzn.to/3LvOuIj • Disclaimer: • Due to factors beyond the control of Hank's Garage, I cannot guarantee against improper use or unauthorized modifications of this information. Hank's Garage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Hank's Garage recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Hank's Garage, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Hank's Garage.

#############################

New on site