SCT Handling Interface

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=dHutnJIc53o

SCT (Download in www.enavales.com) • WORKING PROCEDURE • 1. DEFINITION • •Introduction of the general data for the ship • •Definition of the materials we need to use in this project : mats, rovs, types of steel or/and aluminum, woods, etc • •Define plates and stiffeners to be used at every zone. • •Specify the zones we need to divide the structure, which plate to use for every panel and type of stiffener for frames and longitudinals bordering the panel. • 2. CALCULATION • Once all dimensions have been defined as well as the position of every element in the structure, the application will deduce the real properties for everyone, and comparing them with the ISO Standard 12215.-5 requirements. • These requirements will appear on the fourth column of the table, marking with red color those properties below the requirements. • 3. CHECK • Looking at the results we can decide the convenience or not of modifying elements properties, spacing of stiffeners, the plate assigned to each panel, etc. • 4. ANALYSIS PLY BY PLY • After properly tuned the structure, it is possible, if desired (sometimes it is compulsory) to carry out an analysis ply by ply. This analysis will provide the degree of acceptance of each layer and, as a result, the possibility of decreasing thicknesses without exceeding allowed design stresses and moments. • The application carries out this task with no more than to act on the toolbar's button indicated in annexed figure. All the necessary data are present in the different tables of the various elements and available to SCT. • On a template, specially prepared for this purpose in MS Excel, and fully similar to the one showed in the ISO Standard 12215-5 , will be arranged the results of the analysis. • Any amount of analysis can be performed and all of them will be added into a single Excel file. • 5. OUTPUTS • The button in the toolbar of the Scantling window creates a document in MS Word with the data introduced for the study, the table properties for each element as well as the results for them. • Writing in Word is a slow procedure and, given that the structure may have a lot of components, it may last several minutes. • In the calculations of each panel or reinforcement are used several pressures and coefficients that can be displayed in a separate window, if we click on the figure. • The list of results in MS Word also displays these values. • 6. ANALYSIS PLY BY PLY ISO 12215-6 • The ply analysis for each panel or stiffener are shown directly in an Excel Work Sheet specifically prepared for this study. • 7. RUDDERS ISO 12215-8 • Calculation of any type of rudders. • 8. SCOPE OF CALCULATIONS FOR SCT DEMO (30 DAYS) • · 12215-5 Fibres, Woods, Metallics/12215-5 Fibras, Maderas, Metales • · Plies Analysis, plates and stiffeners/Análisis por capas para laminados y refuerzos • · 12215-6 • · Continuous Beams/ Pórticos y Vigas contínuas • · Rudders, 12215-8/ Timones, 12215-8 • 9. RESUMEN • SCT es un programa que ayuda al proyectista en la definición de los escantillones de embarcaciones de recreo, siguiendo la Norma ISO 12215-5, dentro de los límites definidos por la misma. Este programa tiene las mismas atribuciones que el SCT Professional. • http://www.enavales.com/index.php/tie...

#############################

New on site