FLAT ROOF LEAK REPAIR Commercial Roof Flashing TURBO POLY SEAL

>> YOUR LINK HERE: ___ http://youtube.com/watch?v=n8MgjbBPCa8

Flat Roof leak repair. How to install flashing on a commercial roof. Fix any water leak on all roofs. DIY When the existing flashing of roofs is messed up with tar and caulking, don't worry. Watch this easy way to replace the flashing without removing the old one. • Most leaks are from flashing on flat roofs. • More videos on flashing - • Flat Roof Leak Repair - Full details ... • Leaks on Flat Roofs caused by flashing - • FLAT ROOF LEAK REPAIR | The MAGICAL l... • Turbo Poly Seal - https://bergstromm.com/product/turbo-... • FTC Affiliate Disclaimer - I get commissions for purchases made through links in this post. • 00:00 Start • 00:20 Pointing the problems • 01:19 Paint on Turbo Poly Seal • 02:18 Second coat of Turbo poly Seal • 03:15 Adding Granules on the Wet Turbo • 04:38 Pointing Crack in the flashing • 05:00 Sealing Crack on wall • 05:27 The End Bla Bla Bla • Turbo Poly Seal https://bergstromm.com/ • How to repair the flashing on a leaky flat roof. • Follow these steps: • 1. Remove all old caulking and tar that was used to seal the flashing • 2. Use an angle grinder with a hard-wire steel cone brush to remove about five inches of paint on the brick or cement wall above the metal flashing • 3. Wipe the metal flashing thoroughly with lacquer thinners to remove any residue of silicone from the metal • 4. Use masking tape to seal about three inches on the wall above the metal and also 2 inches below the grove on the metal. (this is for making it look clean when done.) • 5. Apply one coat of Turbo Poly Seal, covering the entire area between the two masking tapes. • 6. While wet, embed the Polyester Fleece into the Turbo Poly Seal • 7. Apply a coat of Turbo Poly Seal to cover the entire fleece • 8. Wait 10 min and then remove the masking tape. • 8. After 30 minutes, the Turbo Poly Seal flashing can be painted with urethane-based paint.

#############################

New on site